Description: Condition: 100% Brand New Item Name: Gearbox Display Indicator Size: 4cm*4cm*4cm/1.57in*1.57in*1.57in*1.57in Function: Shows the current number Gear Indicates the current gear from 1st to max. 6th, as well as the neutral indicator. Automatic programming Compatible with all motorcycles, quad bikes, bikes etc. Will fit anything with a shift lever oacute; the red backlit display automatically dims at night. Detects the current gear faster than other gear indicators that use the speedometer/tachometer signal. Display can be mounted anywhere Install: To find the gear display plug as Smoku technology to the product, then connected to the power line and the speed signal line is inserted into the tank below! Once the monitor is in place, check the cable for damage to the steering system! Step: You need to configure this module after installation. Only do setup when the engine is warm so that the idle speed is normal, find a long, straight road with light traffic. The unit does not learn the same gear twice, this makes it easier to set On Road. If necessary, you can even swipe the wd oacute;ł and pause during setup. Don't stare at the display, watch the road and drive with the utmost care as always! Turn on the ignition. It will count backwards (6 to 1), indicating that the memory is clear. When "L" is flashing, keep the engine in neutral and allow the engine to idle. When "1" flashes, select two-position. Release the clutch and stare normally. The display flashes faster while the device learns the hardware. When display shows "n" (next), select two-position. Repeat this process until all runs have been thought of. In high gear, wait until "o" (end) is indicated and the display stops flashing. The device is now programmed and should indicate all gears correctly. When the ignition is turned on, it will flash forward (1 to 6) to indicate that it is programmed and fully functional. Rest: If some gears are not indicated correctly, please reset your device and set it again. If you change the transmission (install a new front or rear sprocket) or install a speedometer (or other speedometer calibrator), you will probably need to reset and re-set it. Cut off the power to the unit 6 times in a row while the display counts and shows 3,4 or 5. You can turn the display on/off by turning the ignition key on/off. In the next power up, it will display counting backwards (6 to 1). The memory is now clear and you can complete the setup procedure. Warranty: The device is completely sealed and encapsulated with epoxy resin, providing extreme protection of the internal parts against shock, vibration and water. To ensure trouble-free operation from day one, all units have been thoroughly tested before shipping. Our dealers offer a 30-day money back guarantee on HealTech products, so you'll get your money back if the product doesn't meet your expectations. (All parts must be returned in original condition to receive a full refund.) Additionally, the product is covered by our 2-year replacement warranty from the date of purchase. Equipment: For Yamaha Mt-01 2005-2012 Motorcycle Package List: 1 x Motorcycle Gear Box Display