M6S HUD Car Head Up Display Auto Electronics KM/h MPH OBD Overspeed Security Alarm Windshield Projector Display Car RPM Meter Features: 1. Decoration light2. Engine speed3. Fault code alarm icon /Water temperature alarm icon /voltage alarm icon/Fatigue driving reminder icon4. Light sensor5. Unit for multi-function: -degrees Celsius, KM/H-kilometer per hour, V-voltage ,MPH-mile per hour,-Fahrenheit6.Multi-function switch zone: vehicle speed / voltage /water temperature /when car power off, this place can show single driving distance7. Set icons and buzzer icon OBD Troubleshooting: 1.The screen without any display, and no powerPlease do these operations:If OBD cable is tight enough,pull the OBD cable down several timesTry another car to testPlease maintain the OBD interface if it is damaged.2.When HUD power on, HUD only shows the voltage and be automatic power off after 30 seconds driving.HUD just available for cars with OBD2 and EU-OBD agreement(European:manufactured after 2003, Other region: after 2007)HUD Products dont support JOBD and OBDI, It is recommended to change the trolley test.3.Wrong operation lead to crashesIf your car equip with other OBD devices or If your car had been modified will cause a crash,unplug other OBD devices and do the factory settings (more details please refer to the menu table)4.Inaccurate SpeedPlease check if the speed unit is correct,the default is KM(speed unit switching reference setting item)After the power is turned on normally, pre the dial button for 2 seconds to enter the system setting. Push right to adjust the speed adjustment and fine-tune it.(If the dashboard displays 100 Km/h, HUD displays 105Km/h, adjust the default from 107 to 102)5.HUD turn off when step on the brakes, wait for the traffic lights or automatical start and stop the car.For Start-stop car, when it been braked, the engine will stop running,then HUD will turn off. Please find menu 13, adjust the default to 180 ( means 180 seconds)6.HUD can not auto power off(RPM or Speed not at 0)When HUD is power on,long pre in the button for 5 seconds to enter into menu,set to menu 12. Change the voltage from 0 to 13.2V or 13.5V. Once the adjustment finished,long pre in the setting button for 5 seconds to save and exit.7.After HUD power off, restartFind menu 12, adjust the default voltage to 13.6-13.8 V Auto-match models, plug and playAccording to OBD or EUOBD,( the on-board auto-matic diagnosis system) plug and play.- Judgment method:Open and find the sticker under the hood.lf OBD2 CERTIFILE can be installed (as shown in Figure 1)Or check whether there is an automobile diagnosis port under the steering wheel (as shown in figure 2)(u.s. cars can be used after 2003 and most other cars after 2007.) Technical Parameter 1.Environment temperature:-40C +80C Barometric pre: 86-106KPa2.Relative humidity:10%-95% Environment voice:<=60dB3.Work voltage:11V~18Vdc(12Vdc/200mA)4.Standby current: 20mA5.Display channel : LED Display Package Included: 1 x Head Up Display About Q&A Q:Are the product photos real?A:Yes,All the photos displayed are 100% real.and photos are all taken by ourself.But maybe there are some color shading because of monitors.Q:How do I pay for my purchase?A:we accept the following payment methods: