Features: 1. Two motherboards are equal to two machines, each motherboard can control 32 perm rollers, two people perm when one with the left screen, one with the right screen. 2. With measuring bar hole, can test the bar voltage, or bar short circuit can be called out by voice. 3. If power switch and total safety machine panel did not respond, need to protect the seat and replace a new fuse. 4. Equipped with 24V digital bar, it has more accurate temperature and can uniform heating. 5. Comes with the 360℃ rotate wheel, this machine moved smoothly and flexible to turn around even in a narrow space. Specification: Item Type: Perm Machine Material: ABS Optional Type: EU Plug 220V, UK Plug 220V, AU Plug 220V Power: 1000W Input Voltage: 220V Output Voltage: 24V Machine Temperature: 40-160℃ (adjustable) Package List: 1 x Perm Machine 4 x Wheel 1 x Adaptor 1 Bag x Rubber Band 2 x Pipe 2 Bag x Electric Hair Paper 2 Bag x Insulated Cotton 64 x Rollers (10 x 13#, 20 x 16#, 24 x 19#, 10 x 22#) 2 x Holder Operation Steps: 1. Connect the power and press the main power on (the colored lights flash or the display screen is on). 2. Press the start/pause button of operation panel (the display screen lights up and enters standby state) 3. Select different modes and adjust the required time and temperature according to requirements. 4. Press start/pause again to start the countdown. 5. Stop or pause the work midway press start/pause button, and then press start again when working. 6, stop using, turn off the power main switch, unplug the power plug. 7. When the work is finished or the use is stopped, first turn off the power, and then unplug the power connector after the hot rod is cooled. Perm Tips: Extremely damaged hair: 15 minutes; Damaged hair: 20 minutes; Healthy hair: 25 minutes; Hard and coarse hair: 30 minutes; 1. Shampoo your hair after a trim, and blow it to 60 to 70 percent dry 2. For soft hair, apply the soft hair agent for 10-20 minutes to check the softening effect, and then rinse after the effect is achieved. 3. After softening and rinsing, blow it till it is 60-70% dry. Put heat rods on the hair and wear heat insulation pads after putting on the modeling heat rods 4. After the effect of the perm or the setting time of the perm is over, remove the hot rod after cooling and the perm is over. Note: 1. Use the heating rod that is consistent with the input voltage of the machine (if used, check whether the surface of the rod is worn or deformed, and do not use it if found); Choose high temperature resistant high quality perm paper and insulation cotton. 2. Do not allow the water agent to penetrate into the power plug of the heating rod when applying the perm and setting water, so as to avoid the generation of static electricity or electricity leakage. 3. Do not use any corrosive bronzing agent to avoid electricity leakage caused by corrosion of the heat rod and infiltration of the heat source. 4. Insert the power plug of the heating rod before starting the machine. If there is any abnormality in the heating process, please immediately cut off the power to check. 5. Use a power supply that is consistent with the input voltage of the machine and has a ground wire 6. After use, it is better to use the heat rod in time and blow dry it until the following time. Never rinse it directly with water. 7. Please do not use the heating rod again if it is found to be worn or deformed. 8. Do not pull the power output line and move the machine when perming. 9. Do not use the power cord if it is found to be damaged or aged. 10. When stop using, please turn off the power and unplug the power plug.