MontAna Infrared Heater
The Montana infrared heater provides transitive INFRA-red heating. The air, which is optimally heated by infrared lamps, spreads quickly and evenly through the entire space. This is called Transitive infrared heating, unlike static infrared heating (which only gives off radiant heat in the immediate vicinity of the stove). How to use: 1-Plug in the Power Socket 2-Switch the heater on with the main on-off switch on the back side of the unit. There is now a red indicator light that uses bad 0.1 watts. 3-Use the remote control or press the Power button on the front of the heater to turn the heater on. Turn off: Turn the heater off with the remote control or press the Power button. The Fan will continue to run until the thermostat in the heater is adequately cooled. Do not unplug the power cord or turn the heater off with the ON/OFF button on the rear side of the heater as the thermostat is disconnected. If the fan is no longer running, you can turn the power switch off and/or disconnect the power cord from the power outlet. Heating capacity up to 60 m2/150 m3. Four infrared heating tubes, each 375 watts. Low noise fan. Direct Flow warm-up room. 2 modes: Low 750 Watt/High 1500 watts. ECO system for economical power consumption. Electronic thermostat with overheat protection. Panel and display. On/off Timer. Fireproof steel cabinet around the stove. Dimensions: 33 x 19.2 x 30.5 cm. overheating, security switch. Including remote control. Warranty 2 years Gift box 39x24x16, 5 cm weight 5.95 kg advantage versus jet heaters: no production positive ions. No drop in humidity, healthy "sun" air heating.