Temperature Controller Digital Microcomputer Intelligent Thermostat Protector Switch 1500WEU Plug 220V

1、The thermostat has a high-brightness digital tube, which can clearly display the readings during the day or night. 2、The shell is made of ABS material, and the ultra-thick design increases the mechanical strength, good electrical performance and anti-aging. 3、-50~110℃ ultra-wide temperature control range, 0.1℃ temperature control accuracy, suitable for various temperature environments. 4、Unique waterproof stainless steel probe design, resin sealing treatment, waterproof and no rust. 5、Adopts wiring input and output design, which is more convenient to use, and is used in various industrial control equipment. <p class="wang-edit-text"><p class="wang-edit-text">Item Type: Temperature ControllerMaterial: ABSTemperature Measuring Probe: NTC10KSensor Wire Length: Approx. 2m / 6.6ftTemperature Measurement Range: -50~110℃Temperature Measurement Accuracy: ±0.1℃Output Current: ≤10ASupport Power: ≤1500WSize: Approx. 147 x 96 x 45mm / 5.8 x 3.8 x 1.8inUses: Widely used in the field of incubation, equipment chassis, air conditioning systems, temperature control protection and other fieldsHow to Use: 1. Set The Temperature Calibration: If The Real-time Measured Temperature Is Different From The Actual temperature, press this key to adjust; method: Long press the calibration key to display ADJ and flashing words, press the up and down keys to adjust, then press the enter key to save and exit2. Set The Stop And Start Temperature: Press the set button once, the stop temperature flashes, press the up and down keys to adjust; press the set button again, the start temperature flashes, press the up and down keys to adjust, press the enter key to save3. Restore Factory Settings: After power-on, press the up and down keys at the same time for more than 3 seconds, after displaying 888, the recovery is successful; when LLL is displayed, it means that the temperature sensor is not plugged in, disconnected, or damaged, just replace it; when HHH is displayed, it means it exceeds 110℃ measuring range, or the sensor is short-circuited, the sensor needs to be replaced.<style> .wang-edit-text{ font-family:'Arial' !important; } .wang-edit-text table { border-top: 1px solid #000; border-left: 1px solid #000; } .wang-edit-text table td, .wang-edit-text table th { border-bottom: 1px solid #000; border-right: 1px solid #000; padding: 3px 5px; } .wang-edit-text table th { text-align: center; }</style> 1 x Temperature Controller